16 Permanent 1-1/4" Sled Leg Glides Color:White The welding will cause the

The welding will cause the part to burn so you will need to clean the welded foot after the welding by sanding wire wheel polishing or sand blasting before they are prepared for paint

Exact measurements: 1

Center of top hole to center of middle hole is 5 5/16" and center of middle hole to center of bottom hole is 3 9/16"

5X Ferrite core split 7MM 500MHZ frequency min: 50MHz frequency max: 500MHz cable diameter max: 7mm ferrite mounting: split core impedance: 35ohm Series: ZCAT

Black round plastic glide fit inside hollow round furniture legs

16 Permanent 1-1/4" Sled Leg Glides Color:White The welding will cause theEasily retro fit sled leg furniture to function on any hard floor surface and eliminate floor scratching on sled leg style chairs and desks. Used for sled leg chairs these sled glides eliminates floor scratching. Easy to install these glides are engineered to fit all sled leg tube sizes and are designed with an internal 7 32" stem (Use 7 32 inch drill bit for installation) to eliminate any potential twisting.